Anti-static rubber sheet is a kind of rubber sheet, most of them are thin rubber sheets. Anti-static rubber sheet is also called anti-static table mat, insulating rubber sheet, which is mainly made by a variety of processes using static conductive materials, static dissipative materials and synthetic rubber.
First of all, before laying, you must know the foundation of the ground. The ground can only be laid if it is a very smooth concrete or terrazzo, tile or wooden floor. The ground must be neat and clean. There is no uneven phenomenon, do not appear a lot of uneven pits, and the ground also needs to have a sufficient strength, no sand and no shelling phenomenon, keep the ground dry, this is the premise of the ground anti-static products laying .
Secondly, clean the ground with cleaning liquid and cleaning agent, connect the ground to the power grid, and use copper bars with a thickness of 0.25mm and a width of 2.5cm. The length and quantity of specific copper bars can be determined according to the width of the ground. Generally A copper bar is used two or three meters apart, but when placing the copper bar, the other end should be led to the ground electrode outside the ground.
Finally, after the grounding conductive mesh is laid, the antistatic rubber sheet is laid on the ground in order according to the method. If there is a large gap on the bottom, you can use a knife to cut it to make the gap as small as possible. After that, apply glue to the places with small gaps and let them dry on the ground for about twenty minutes. Try it by hand without sticking. When the bottom surface is in operation, the method is the same as above. After finishing, roll it with a heavy shaft a few times and keep it for 2 days at normal temperature before using it normally.